One touch power window reset

[Square1]

You may already know this but I just learned it today. I had my battery disconnected when I installed my Injen intake. The One Touch Power window "UP" will be disabled if you have your battery disconnected or it goes dead. To reset it to function again follow these simple steps. - Dano

1. Make sure the windows are all up.

2. Turn the ignition to the on position

3. Hold the window button down but make sure it does not click to go into the auto feature.

4. Keep holding the button down and let the window roll fully down and do not release the button for 5 seconds after the window is fully down.

5. Now raise the window back up but make sure it does not click into auto mode and hold the button up until the window is fully closed. Same procedure, don't release the button for 5 seconds after the window is fully closed/up.

6. Now try the Auto Mode -- click down on the button and release immediate. It should be one touch auto down.

7. Test and make sure the one-touch auto up is now working properly.

[ESP]

Good idea posting this up.  My Alti was much the same except that the auto-down would always work, even after disconnecting the battery...  Go figure!

[Square1]

Good idea posting this up.  My Alti was much the same except that the auto-down would always work, even after disconnecting the battery...  Go figure!

Yeah, the Cube works the same way as your Alti., Auto down worked but but auto up didn't till I did the reset. - Dano

[damian666robin]

ok i just copied all the steps on my phone i know there,s been a previous post about it but i never had the paper and pen or the phone to copy all this stuff so i got it now i will try it tomorrow
i also gotta find out about reseting the air bag light under the stereo cluster i got lazy one day playing with the stereo and i just discontect that plug in the bug so now i been driving with that air bag light on all the time 


thanks man

[Square1]

ok i just copied all the steps on my phone i know there,s been a previous post about it but i never had the paper and pen or the phone to copy all this stuff so i got it now i will try it tomorrow
i also gotta find out about reseting the air bag light under the stereo cluster i got lazy one day playing with the stereo and i just discontect that plug in the bug so now i been driving with that air bag light on all the time 


thanks man

Airbag Reset:

1. Turn the key on.

2. Watch the airbag light closely. It will stay on for a few secs. as soon as it blinks off, turn the key off instantly.

3. Wait 5 seconds

4. Repeat steps 1-3 two more times until you have done the cycle three times.

5. Now turn the key on and watch the light. It will start blinking at a slower rate than above. 

6. Now turn the key off again, wait 5 seconds, and turn ignition back on. If the procedure worked, the airbag light will not be flashing.

- Dano

[damian666robin]

cool thanks man 

[RIXterra]

I know this is a real old thread but my auto up feature never worked from day one I got my Cube. So I did this and it now works just fine.. Thanks for the info..

[Courteau]

Its a bit like the autorelock feature that you can activate/deactivate
It's all in the manuel

[Jerry]

I think my Cube must be broken.  I'd better call the dealer.  I disconnected the battery to do some work, and when I reconnected it, the auto-up still worked fine.

Weird science!

Jerry

[Courteau]

depend how long you let it disconnected.

[jspectoaster]

what if you have the push button start??